Shenzhen Tongcheng automation equipment Co., Ltd.
Q Q : 443231019
Phone : 0755-33199429
Mailbox : email@example.com
Web site: www.toolcen.com
Factory address: Shenzhen Baoan District Shiyan Street Bay Village Yue Chang Industrial Park
Office address : room 13, 12 floor, 232 stone East Road, Shiyan street, Baoan District, Shenzhen
First of all, you have to turn off the air pressure, adjust the position manually, prevent the damage to the brush and the manipulator, then adjust the mode first, that is to say, it is the suction or the clip. Then you can open the air pressure by manual operation once, and then adjust the time, after that. Open automatically, check whether there is alarm sensors, can be produced. After debugging the injection molding machine manipulator is installed debugging and production debugging speed, machine can slow down, as long as the speed of debugging is good, the production is different, to the injection molding machine manipulator to you with injection molding machine debugging.
In terms of injection molding machine manipulator speed are used to control the pressure (mold release action: the main arm down the main arm forward, the main arm and the main arm back arm, the main fuselage main arm swing, rise, decline, the main arm and the main arm rise, body rotation, the main arm reset.) these are the injection molding machine manipulator is used to adjust the time for action.