Shenzhen Tongcheng automation equipment Co., Ltd.
Q Q : 443231019
Phone : 0755-33199429
Mailbox : email@example.com
Web site: www.toolcen.com
Factory address: Shenzhen Baoan District Shiyan Street Bay Village Yue Chang Industrial Park
Office address : room 13, 12 floor, 232 stone East Road, Shiyan street, Baoan District, Shenzhen
On the application of injection molding manipulator:
One or two plate die:
(1) automatic demoulding
The clamping head, separating head (clip head, let the product automatically be separated and refined material).
The separation of different state of the products (clip or hold head, learn to take the finished product separation of finished product and material).
Or take hold of finished product separation suction (suction or take hold finished, let head off automatically separation of finished product and material).
(2) manual demoulding
The clamping head (finished with a head together, manipulator is taken out and then the artificial separation of finished product and material).
Learn to take the finished product (or hold product and material together with mechanical hand draw or take hold of finished products).
The clamping head, absorb or hold and take the products (finished in the top head injection, and has finished material separately,
Remove the manipulator, can be placed respectively in different material and products.
Two, three plate die:
(1) the product can automatically fall off head can not automatically fall off
The clamping head, finished off automatically, the separation of finished product and head (manipulator arm).
Draw or hold from finished product arm, head arm clamping head, the manipulator for separation of finished product and material (double manipulator).
(2) products, can head off automatically
Draw or hold from finished product arm, head arm clamping head. The separation of product and head manipulator (the manipulator arms).
Head arm clamping head, let the product arm sweep product to reach the automatic stripping mode, separation of product and material.
Hint: using the manipulator, if the finished product has inverted buckle, it should not affect the finished product directly after the top out of the finished product.
Therefore, when developing the mold, we should consider whether the product is suitable for use by the manipulator.